2PC Flanged Ball Valve

Buy 2 High Quality Flanged Ball Valve From Our Factory with High Quality in China
1.Introduction of 2 Flanged Ball Valve

In the 2 flange ball valve structure produced by milestone valve company, the flange is connected by bolts, and the seal is made of reinforced polytetrafluoroethylene inlaid into the stainless steel ring. There is no spring at the back of the steel ring to ensure that the valve seat is close to the ball and keep the seal. There is no PTFE bearing on the upper and lower valve stems to reduce friction and save labor. There is no adjusting plate at the bottom of the small shaft to ensure the joint position between the ball and the sealing ring. 2 flanged ball valve is full diameter for pipeline cleaning.

2. Technical Parameters of 2 Flanged Ball Valve

	2 flanged ball valve
DN	DN50～DN1400
PN（MPa）	1.2～20Mpa
Design Temperature Range	-15℃～425℃
Applicable Medium	Water, oil, gas, and various corrosion medium
Connection type:	Flanged
Actuator type	Manual drive, Pneumatic, Hydraulic or electric Actuator
Sealing	Metal Hard Seal

3.Characteristics of 2 Flanged Ball Valve

1) The operation of 2 flattened ball valve is labor-saving: the ball is supported by the upper and lower bearings to reduce the friction and eliminate the excessive torque caused by the huge sealing load formed by the inlet pressure pushing the ball and the sealing seat;
2) Reliable sealing performance of 2 flanged ball valve: PTFE single material seal ring is embedded in the stainless steel valve seat, and spring is set at the end of metal valve seat to ensure sufficient preload of seal ring. When the sealing surface of the valve is worn during use, the valve will continue to ensure good sealing performance under the action of spring;
3) 2Flamed ball valve has fireproof structure: in order to prevent the polytetrafluoroethylene sealing ring from burning due to sudden heat or fire, causing large leakage and fueling the fire, a fireproof sealing ring is set between the ball and the valve seat. When the sealing ring is burned, under the action of spring force, the sealing ring of the valve seat is quickly pushed to the ball to form metal to metal seal, Play a certain degree of sealing effect.
4) 2 Flanged Ball Valve has a drain line： when the pressure of the stagnant medium in the valve cavity rises abnormally and exceeds the preload of the spring, the valve seat will retreat from the ball to achieve the effect of automatic pressure relief, and the valve seat will reset automatically after pressure relief.

4.Application of 2 Flanged Ball Valve

5. Packaging and Delivery

6. FAQ

1. Can i have a sample order for valve ?
A: Yes, we welcome sample order to test and check the quality, Mixed sample are accepted.
2. Do you have any MOQ limit for valve order ?
A: Low MOQ, 1 PC for sample checking is avaible.
3. Could you offer OEM service ?
A: Yes, OEM is availble.
4. How about the payment ?
A: We normally accept 30% deposit, and balance will be paid before shipping. L7C is OK
5. Whafs the delivery time of your butterfly valves?
A: For most of the sizes,DN50-DN600,we have stock of valve parts,it*s possible to deliver in 1-3 weeks,to nearest seaport Tianjin.
6. Whafs the warranty of your products?
A:We normally offer 12 months of warranty in service or 18 months since shipping date.
7. What is your products standardization?
A: GB/T12238-2008, JBfT 8527-1997, API 609,EN 593-1998, DIN 85003-3-1997

7.Contact Information